Announcement

Collapse
No announcement yet.

Anybody using one of these? Need Opinions

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Anybody using one of these? Need Opinions

    I am wanting to purchase these two items for my Hardinge. Anybody already own either of these and your comments?
    I am looking at the 5C collet on the toolpost for holding all different diameter boring bars. I was trying to figure out how to use my ER32 or ER16 setup but by the time I figure in the diameter of the collet nut I could install the 5C collets, of which I have many, many different sizes, shapes, etc.
    I need the rotating tailstock chuck for holding long thin rods for less deflection during machining than using a center.
    Opinions are appreciated.




    Edited to add photos
    Last edited by YankeeMetallic; 01-07-2007, 09:40 PM.
    Duke Reno / Yankee Metallic Metalcraft

  • #2
    No, but I think someone could make it cheaper.Where is that guy on here that always boasts about how he can CNC things cheaper. I would take one for $50, any others?

    Comment

    Working...
    X