If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Where could I find a set of prints for a horizonal steam engine of say 3"bore either one or two cylinder?Also a walking beam of the same dimen.would be nice.
Ray Hasbrouck at http:hasbrouck.8m.com/index.htm has several engine plans without castings, including a single cylinder with reverse gear 2-1/4" bore x 3" stroke. Put two together to make a twin.
Tweet
Engine prints
.png)
Comment