Announcement

Collapse
No announcement yet.

Lathe Identification

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tiptop
    replied
    Bill,

    Just a guess, but I would say somewhere between 1927 and 1931 SB. The South Bend Forum will have your correct answer.

    Jay

    Leave a comment:


  • Oldbrock
    replied
    looks like SB to me, go to practical machinist site and go down to south bend lathes and give them the serial # they will identify it for you. Peter

    Leave a comment:


  • Teenage_Machinist
    replied
    +1 on southbendyness. My school has a lathe like that left over from when they had a metal shop .

    Leave a comment:


  • Bill Graham
    replied
    Mark,

    Thanks, that looks just like mine ( but without any southbend identification ).

    I think with some cleaning it should turn out to be a nice machine for me, and with it now being properly identified I should be able to find any missing pieces I might still need.

    Thanks again for your help.

    Bill Graham
    Phoenix, AZ

    Leave a comment:


  • Mark Hockett
    replied
    Bill,
    It looks like a 1920-1930 South Bend.
    http://www.lathes.co.uk/southbend/page6.html

    Leave a comment:


  • Bill Graham
    replied
    photos

    here's a link to a webpage where I put photos of headstock, carriage, tailstock, and ways.

    http://www.techstool.com/garage/lathe2.htm

    Any help would be appreciated.

    thanks

    Bill Graham
    Phoenix, AZ

    Leave a comment:


  • tigmusky
    replied
    let see a pic someone here will get you pointed the right way.

    Leave a comment:


  • Fasttrack
    replied
    A picture might help!

    Also, you can see if you find it on www.lathes.co.uk . It doesn't have every lathe manufacturer, but it has a pretty good number. Usually if you post a picture, someone here will recognize it.

    Leave a comment:


  • Bill Graham
    started a topic Lathe Identification

    Lathe Identification

    I picked found an old, neglected, metal lathe at an estate sale today, the price was right and after a quick inspection I thought at worst I could use some of the tooling & chucks on my 10" logan. I looked all over and couldn't find a manufacturer stamp, plate, or inscription, but using a borrowed tape measure it looked like it was an 11" lathe and the spindle matched my 1 1/2 x 8.

    Got the beast home and got my first oops; found that what I thought was 1 1/2 x 8 was actually 1 5/8 x 8. I've looked over every inch of this lathe and can find no manufacturer identification of any kind. There misc casting on some of the parts including the bed and there is also a serial number stamped in the far right side

    How do I go about finding out who made this lathe? Is there a website somewhere that leads you through identifying machine attributes to correctly identify?

    What kind of additional information can I post that would make it easier to assist me?

    Thanks

    Bill Graham
    Phoenix, AZ
Working...
X