Bevel gear for servo needed

[GKman]

Bought this servo with electrical issues that I'm getting sorted out but I don't have the bevel gear to adapt to a lead screw. In desperation bid one up to $30.00 + not knowing if it would even mesh with the gear on it. Somebody wanted it worse. Another one coming up on EBay this week but there must be a source for one that I know will fit. Any suggestions for a source?

[Just Bob Again]

http://www.icai-online.com/product.p...cat=322&page=1

[J. R. Williams]

Gear

Check with the Servo company as the unit is very similar to the older Servo drive units.

JRW

[lakeside53]

That looks like and old Servo model 70..

I have several bevels that fit 140 and 150's. Measure the rough diameter and post it. I'll check mine.

[GKman]

That looks like and old Servo model 70..

I have several bevels that fit 140 and 150's. Measure the rough diameter and post it. I'll check mine.

Thanks for the quick response all of you. I pride myself in being a pretty good googler but I gave it my best shot before posting here.

Maxim OD would be 3.0" Something on the gear wore a shiny ring in the case about 2.3" ID X 2.5" OD. There is a needle roller bearing with no inner race that would fit a shaft around 1.015"

Just Bob Again and J R Williams,
Looks great if lakeside53 doesn't have anything.

Thanks again.