Announcement

Collapse
No announcement yet.

Bevel gear for servo needed

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Bevel gear for servo needed

    Bought this servo with electrical issues that I'm getting sorted out but I don't have the bevel gear to adapt to a lead screw. In desperation bid one up to $30.00 + not knowing if it would even mesh with the gear on it. Somebody wanted it worse. Another one coming up on EBay this week but there must be a source for one that I know will fit. Any suggestions for a source?







  • #2
    http://www.icai-online.com/product.p...cat=322&page=1

    Comment


    • #3
      Gear

      Check with the Servo company as the unit is very similar to the older Servo drive units.

      JRW

      Comment


      • #4
        That looks like and old Servo model 70..

        I have several bevels that fit 140 and 150's. Measure the rough diameter and post it. I'll check mine.

        Comment


        • #5
          Originally posted by lakeside53
          That looks like and old Servo model 70..

          I have several bevels that fit 140 and 150's. Measure the rough diameter and post it. I'll check mine.
          Thanks for the quick response all of you. I pride myself in being a pretty good googler but I gave it my best shot before posting here.

          Maxim OD would be 3.0" Something on the gear wore a shiny ring in the case about 2.3" ID X 2.5" OD. There is a needle roller bearing with no inner race that would fit a shaft around 1.015"

          Just Bob Again and J R Williams,
          Looks great if lakeside53 doesn't have anything.

          Thanks again.

          Comment

          Working...
          X