.png)
Tweet
help holding odd work piece.
I have no idea how i would hold these knife handle so i can mill some simple flats. I dont know how i would get these in the vise straight. There are no flat edges anywhere on the sides so i have no idea on how to hold it straight.
-
-
put them in a little shallow pan, and melt some "CerroSafe " or similar low temp metal around the work piece. -
Using two or more of the available holes in the handle pieces, screw them down to a bar which will be held in the vise.
DavidDavid Kaiser
“You can have peace. Or you can have freedom. Don't ever count on having both at once.”
― Robert A. HeinleinComment
-
Clamp them in the vise between to hardwood blocks wide enough to permit the cutter, then mill the flat through the wood as necessary.Comment
-
Flats
If the flats are on the larger face (side?) just clamp it to the mill table.
If the flats are on the lesser face (top/bottom?) just clamp it to an angle plate.Comment
-
I vote with 38_Cal: screw them down to a block.----------
Try to make a living, not a killing. -- Utah Phillips
Don't believe everything you know. -- Bumper sticker
Everybody is ignorant, only on different subjects. -- Will Rogers
There are lots of people who mistake their imagination for their memory. - Josh Billings
Law of Logical Argument - Anything is possible if you don't know what you are talking about.
Don't own anything you have to feed or paint. - Hood River BlackieComment
Comment