Announcement

Collapse
No announcement yet.

Looking for 7/32 tap

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Brent,
    I have two 7/32 NS x 40 taps made by GTD if you're interested.
    Yours for the asking...

    Joe

    Comment


    • #32
      Joe,
      I would be interested in one.
      I will PM you my info.
      Still holding out for a 7/32"-24 to complete my set
      thank you

      Comment


      • #33
        Originally posted by Bmyers
        And I was just hoping to find a tap...
        No dice so far. Still looking.

        Comment


        • #34
          Here is one
          http://www.ebay.com.au/itm/7-32x24-4...item3cbadb8d67
          Tel

          Comment


          • #35
            I have some taps made by LLG and CO Berlin which are marked 7/32 x 24. I have had these for over 40 years and never used them, and reckon they were about that age when I got them. I was given these by an old toolmaker and he must have been in his seventies or eighties at the time, I have the taper and bottoming taps, both still sharp. Any good ? David

            Comment


            • #36
              do they have any other markings ?

              Comment


              • #37
                No but as I live in England would be fairly sure there Whitworth. David

                Comment


                • #38
                  Joe, tap arrived.
                  Bump, still looking for 7/32-24 tap

                  Comment

                  Working...
                  X