turning 1.750 coldroll

[macona]

How big of lathe? What kind of cutting tool?

[Toolguy]

Lathe

Anywhere from .020 to .100 depending on the lathe and setup. If the tooling is up to it, I would run 1000 RPM or more.

[Slick1]

sorry

I thought I was in the general section.

[Slick1]

Hey guys I need to taper some cold roll 1.750 dia. I am tapering back 1 inch from the end and tapering down to 1 inch dia. on the end. How much do you guys normally take off on each pass doing this kind of operation. I am turning about 330 rpms and not getting blue chips but was wondering how some of you do this.
Thanks David