No announcement yet.

Outside chuck jaws up for grabs ---

  • Filter
  • Time
  • Show
Clear All
new posts

  • Outside chuck jaws up for grabs ---

    I recently bought 2 old lathes and along with them was a couple boxes of misc odds and ends (mostly junk!) but a few goodies. These jaws were among the goodies. They wont fit anything I have, and I KNOW how hard it can be to find jaws sometime, so hopefully someone has a chuck without outside jaws that one of these sets will fit -- pay the postage and buy me a cup a coffee for the trouble to package and send them, probably $10 should do.

    They are in very good condition, I ran them through the bead blaster...

    The ones in the middle have no markings, other than the normal 1-2-3, dims shown.

    On the right has the '410 MAX' marks and a logo type emboss that is a stylized "S" and the 1-2-3 - I bout covered up the dims, so - .748 thick, 1.544 length, and 1.890 depth

    On the right is a set of inside jaws that one - obviously - has one jaw with broken teeth, but in case anybody needs the other 2.....

    PM or email me...

    If everything seems to be going well, you have obviously overlooked something........