Long 3/32" burr

[radkins]

I am looking for some 3/32" carbide burrs at least 1 3/4" long, I bought two last year from a site I found on the 'net but try as I might I can't seem to find anything longer than 1 1/4" now. Last year when I discovered I needed these things I just went to Google and searched a couple of sites and there they were so I "assumed" these are common and it would be easy this time too but apparently not. What I need is a 3/32" cut dia. and a 3/32" shank, I can not use a 1/8" shank due to clearance problems. Any suggestions on where I might find these things?


I can't remember the name of the company I bought them from last year, only that it was a hobby supply.

[Arthur.Marks]

This help?
http://www.artcotools.com/super-carb...ip-3-32-shank/
Shanks are 3/32" diameter x 1.75 long

[RussZHC]

http://www.bursforcarving.com/HPBurs1.html



gesswein is other there too but I could not find any general or specific mention of length. Found a couple of others as well but many seem to list diameter and cut length but not overall length (which I assume is the 1 3/4" measurement you are looking for) [the space above was for moldproducts but their website is sort of odd, toggling between two different sizes of shank...]

[Doozer]

If you can't find what you need,
I bet Harvey tool can make it for you.
In carbide even.

--Doozer

[radkins]

This help?
http://www.artcotools.com/super-carb...ip-3-32-shank/
Shanks are 3/32" diameter x 1.75 long

I can't find the 1.75 length on that site all I can find is the 1.250?

[Arthur.Marks]

All of the burs in the category I provided a direct link to (Super Carbide Burs Handpiece Grip) are 1.75" shank length. For example:
http://www.artcotools.com/figure-15l...long-head.html

[radkins]

All of the burs in the category I provided a direct link to (Super Carbide Burs Handpiece Grip) are 1.75" shank length. For example:
http://www.artcotools.com/figure-15l...long-head.html

The ones on that page are only .055 for the largest of the three sizes available but and I needed a 3/32" but they do have a 3/32" shank and it is indeed 1.75" long, all the 3/32 diameter cut I could find are only 1.250" long. I think I can use the largest of the three offered however so I am going to order 10 of them, they sure are cheap enough.

Thanks for the link, I think these may work even if they are a bit small.

[Arthur.Marks]

If you go back to the first link you have a wide selection of tip shapes. They all have a 3/32" x 1.75" shank. Do you need a ⌀.0906"cylindrical square tip? Perhaps a ⌀.0906" spherical one? You get the idea...