Atlas 618 Tool Slide

[Drf255]

I need one if anyone has extra parts

I don't see a trading post on this forum.

It's part No.M6-303.

Mine is cracked. I brazed, as it wouldn't weld. Appears to be cast iron. Mine cracked again.

If anyone has one to part with, please PM me.

Thank you.

[Carm]

Can't help with the part.
Have you considered stitching?

[tmc_31]

Drf255,

This may or may not be helpful. In 2006 Clausing listed that part new for $93.24. You might give them a call. Don't know if they are still in business or not.

Clausing Service Center
Phone (800) 535-6553

[Alistair Hosie]

I must recomend you to try J and B weld two part ,it is very good for fixing metal components to each other.I glued a metal stanchion on my large industrial radial arm saw and it ended up perfectly good despite being in three pieces beforehand.You can buy it on ebay for under four pounds for two tubes.Alistair

[Drf255]

$187.97 now. Still available.

Ouch.

[JCHannum]

MyMachineShop is a good source for Atlas parts. Thy do not show the top slide presently, but might turn one up or try contacting them directly.

http://www.mymachineshop.net/category_s/55.htm

It is also worthwhile to watch eBay as parts show up frequently there.

[portlandRon]

If you can you might try putting pins in it by drilling across the crack and then brazing it again.
Sounds like you have nothing to lose by trying.

[90LX_Notch]

I've got one. Make an offer and we'll see if we can make it happen.

-Bob