How many thousanths (.001's) infeed does it normally take to get from male piece starting in the internal almost a full turn to acheiving a better than hardware store fit but easily threaded in with fingers? My attempts seem to take more infeed than I feel like they should. I use full profile bits for both int/ext.

I am troubleshooting my setup. But without knowing what the norm is Im a little behind the curve.

To keep to my question I AM NOT asking about calculating infeeds. .708 x tpi or what not. Specifically asking about the amount of infeed from 1 turn in to finished thread. So I can compare to my situation and then evaluate if Im doing it right. Or if my set up is lacking. Thank you

I am troubleshooting my setup. But without knowing what the norm is Im a little behind the curve.

To keep to my question I AM NOT asking about calculating infeeds. .708 x tpi or what not. Specifically asking about the amount of infeed from 1 turn in to finished thread. So I can compare to my situation and then evaluate if Im doing it right. Or if my set up is lacking. Thank you

## Comment