OT. Cleanup of drywall dust with the shop VAC plugging up fast, Help?

[Mr Fixit]

Hi Guys,

I reposted the proper link to the metal shaping forum. It seems to work for me as far as I went to register, but then maybe it's...

[Mr Fixit]

HI Tundra Twin Track,

Another great tool project out of your shop. That is a great way to hold varied sizes in one setup using the drill...

[Mr Fixit]

Hi Captain K,

Here is a link to a sheet metal forum that I visit that has a lot about the powering and design of bead rollers. The You Tube...

[Mr Fixit]

Hi Guys,

The CA that was used is for plastic application and is this product. https://www.acehardware.com/departme...-epoxy/1008713...

[Mr Fixit]

HI Gellflex,

Here is the product that I used and was suggested by the South Bend forum over on PM when I was just starting out.
...

[Mr Fixit]

Hi Challenger,

I too have only done fly cutting with the type of setup that you have , and only twice before. Let me say what I learned and...

[Mr Fixit]

Hi Gellflex,

I have done this with my South Bend tool room 9" and it has been running for over 8 yrs on the same belt and works like...

[Mr Fixit]

Just needed to use a old grinder and a DA sander with different pads and had to make a couple of adaptors to fit the tools. This was my first successful...

[Mr Fixit]

Get this months HSM magazine, there is a shop crane just for your application. Great article and doable in many scenarios.

TX
Mr fixit...

[Mr Fixit]

Hi Tungsten Dipper,

You can use the new switch, you just have to change wiring in the equipment. The old switch, did it have 2 white wires...

[Mr Fixit]

Hi Group,

Those are some great suggestions. I really like the water separator in line with the Shop Vac. I think I will YouTube a few different...

[Mr Fixit]

Hi Group,

I have a drywall project that I'm working on and have been using my RIDGID 9gal shop VAC to clean up. The darn filter keeps blocking...

[Mr Fixit]

Hi Guys,

I got it after all, but was not able to test it because the fella had moved from his home to an apartment and he didn't have 240v...

[Mr Fixit]

Hi Group,

I have the opportunity to buy a 3hp VFD for a good price and was wanting to test it before I buy it. Can you apply power and run...

[Mr Fixit]

Doozer,

What is the hand wheel on the right side in the pictures for? The ram looks fixed from the picture so I can't see it moving the ram...

[Mr Fixit]

I've had good luck with a pair of modified vise grips that have a slide hammer on the end, I grab the pin and give it a tug and they come out. Of course...

[Mr Fixit]

Hi Rich,

Fantastic tool and right up. I say you copy this post to George and maybe a few pictures and let him have it for a future article,...