Probably home made, seen a bronx I think that was the same size, very old
mark
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
The time and motion guys used decimal stopwatches, suppose it makes sense, to them at least, got caught out with decimal angles a few times, 5.75 degrees...
Leave a comment:
-
There are alternatives, some not so nice, the plastic film industry (blown film extrusion) have severe static problems (hurts like f), sometimes the top...
Leave a comment:
-
-
We had BAs the early Sibe Gorman were bloody heavy, the new drager must have been composite, they were light, or lightish, air receivers aka tanks were...
Leave a comment:
-
Didn’t know that, a friend of mine was an engineer designing reactor stuff, she had a square tube about 10” long that was crushed like a vienetta...
- 1 like
Leave a comment:
-
-
I was told, that the overwheel dresses to the wheel axis not the table, I think that makes sense so I just did as told, worthwhile when inexperienced,...
Leave a comment:
-
-
Horses were measured in hands but I think 1 farmers dick = one hand, problem Texas imports stuff that ends up 1/2 size,
Q, if you need 25000 armed...
- 1 like
Leave a comment:
-
Sounds plausible if the hex bar was cold drawn, there must be a massive stress inside, wonder if the same happens after annealing, I doubt it, perhaps...
Leave a comment:
-
Never regretted paying more for a good calliper, often regretted buying 3 cheaper ones, I’d stump up for a mitutoyo or similar myself, if you use coolant...
Leave a comment:
-
-
Used some ptfe on my van this week, quick squirt it’s good
mark
Leave a comment:
-
Used them a lot on an optical projector, ready made templates for radii on extrusions, hardly ever since, I had mine on a key ring thing for small radii,...
Leave a comment:
-
I know the ones, air over oil intensifiers, I used to have a punch set up with heads on a bed, minidie comes to mind, used a lot on Ali extrusions, actually...
Leave a comment:
-
-
I’ve even seen a case with a mix bucket, cool, hydraulic motor on the end auger in the bucket, I have a case 1845c I’ve thought about it a few times,...
Leave a comment:
-
It only happened once, was in the shop late, or early morning, couldn’t sleep as I had some tooths ripped out by a fang mangler aka Dontist, had a weird...
Leave a comment:
-
White clays usually as said are extruded, holes for fileing, or frogged, ie depressed centre, there are white concrete, but good look reveals sharp sand,...
Leave a comment:
No activity results to display
Show More
Leave a comment: