Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Your right Bob. I had the gears for table feed of .010 and change them for .005.. It made a world of difference. I will go back and edit my original...Last edited by lugnut; 04-17-2021, 06:19 PM.
-
Fixed My Dumb Mistake
With my little 9X20 Grizzly lathe I have to change the gears manually (PITA) So here awhile back I threaded a rod for a project I was dinking on and had...Last edited by lugnut; 04-17-2021, 06:20 PM.
- 2 likes
-
-
Just put them in the back of you pickup's bed and drive it down to the local shopping mall. Go inside and spend a hour or two shopping, and I would almost...
- 6 likes
Leave a comment:
No activity results to display
Show More
Leave a comment: