User Profile

[SVS]

The left right motion is a complication older lathes won’t have. I agree they should move together and I bet something is out of sorts in the hub of...

[SVS]

So What!….. You’ve thrown three tantrums, said you were done with this thread, and now you’re giving updates like a tattling four year old….....

[SVS]

You’d drop the table, same as withdrawing cross slide when threading on a lathe....

[SVS]

Paul-I’ll take a swing at it. Haven’t done it, but have studied it as I have bits and pieces that get me close to having the capability. No need yet...

[SVS]

“ ……..Then they go into my oven, mounted on a special fixture that spreads the ends apart to a "target dimension" for a four hour heat...

[SVS]

Might fit but they will still be to soft. (per numerous recent posts.)

[SVS]

It’s 😎...

[SVS]

Don’t bark at me-I knew what you were being facetious about, AND that you didn’t need remedial education on helical milling....

[SVS]

Paul-TMB knows that-he was being facetious....

[SVS]

There is a good chance it was imported under different names. Widen your net by posting a picture....

[SVS]

Ok-my scroll finger got tuckered out before the actual end. Lot of popups to fight through.

The Cliff notes: Transfer case in neutral NOT...

[SVS]

Less a “procedure” than a “cautionary tale”.

Ouch!

[SVS]

It’s work-able. Been done before.

A buddy used industrial surplus DC gear motor and drive on a big old antique with a half missing loose...

[SVS]

I see a lot of Jeep products flat towed behind motor homes. Transfer case in neutral must be good enough?...

[SVS]

Electrlc is also available....

[SVS]

A couple mechanic friends like their pneumatic band files for general use.

Maybe already mentioned? Haven’t followed the links above....

[SVS]

Interesting to hear a devotee of hand scraping so derisive of hand filing.

I’m avg. at best, but tend to see champher filing as a self...

[SVS]

If you can buy’em for $9, I bet you can make them for $90.

I’m exaggerating, but one end mill and two blanks and you’ll be over $18....

[SVS]

It’s not the HSM way, but, I’d bet any farm supply store would sell you a pair of small sprockets for less than a form cutter will cost.
...

[SVS]

That’s pretty clever!

I was thinking “starter ring gear……that’s preposterous!” As I scrolled down your description....