User Profile

[larry_g]

Thank you to BC rider for your input, that is the information I was looking for.

I wonder if Stefan reads this forum. He recently posted...

[larry_g]

First look at the chucking picture I thought to myself, Why not turn the jaws around and use the thinner section on the other end. I realize...

[larry_g]

I seen those and couldn't identify the brand and assumed they might just be worth the asking price. We might be neighbors.

lg
no neat...

[larry_g]

As a first operation V the raw shafting and then weld it, the V back to size. This will put a stress in the material trying to pull it together. Now...

[larry_g]

Good deal. My wife is involved with the county fair and a few small shows leading up to the fair. She has stopped putting any dates on awards so that...

[larry_g]

The other day I was putting a woodruf key in some 5/8 shafting. Thought I'd make a test cut to make sure I was good with the cutter and key I had. Grabbed...

[larry_g]

Another way is to grind a form tool and cut a slot in the end of the bore with a lathe. That will give you good support to cut the slot. Then mill leaving...

[larry_g]

Something other to consider is the design you use. If you use only a single carriage then it is free to rotate around it's clearances. If you use two...

[larry_g]

Is this a static or rotary converter? There may be issues with rotary converter if the generated leg is on the control circuit. If a static converter...

[larry_g]

In the factory we used Frelon Bearings on linear shafting where we could not use ball bushings. https://www.pbclinear.com/Products/R...Plain-Bearing...

[larry_g]

I disagree, In the OP's post he says "" . In the IC engine the container does yield, the piston moves, so The IC engine changes the force into...

[larry_g]

My sister got caught doing that and was ticketed. In her area it is illegal to relocate wild animals. I believe it is not allowed in a lot of areas....

[larry_g]

I am not a weldor so for a second opinion; I would mill off ~1" off the bottom of that casting and bolt on a steel bar that would bring it back to...