User Profile

[psomero]

Nonsense! If people don't like it, they can go read something else. I happen to really enjoy the refurb stuff...

[psomero]

"Sulfated" would imply that the lead sulfate has gone from fine, easily reversed active material in the discharged state to the coarse crystalline...

[psomero]

General statement without regard to OP but since it was alluded to:
If you're running compressed air in PVC you're an asshole and I sincerely hope...

[psomero]

I used cleaner one time on my 5.3 silverado and my fuel pump was dead half way through that very same tank of gas. Never again....

[psomero]

Definitely not California. If you're throwing codes, you go fix and come back. If you clear the DTC's, the tester will check for the emissions test...

[psomero]

Yup. You need to play around with the relief on the cutting edges, but it's quick work on a d-bit grinder...

[psomero]

Wait, what in the hell are you trying to do?

If you need a height reference of some specific height and very flat, buy a gage block. They're...

[psomero]

The only way you bring sulfated plates back to life is throw them back in the smelter and scrape the sulfates off in the dross before you cast new plates....

[psomero]

Bring on the clown car full of schmucks who swear by ancient POs schumachers

[psomero]

I got some PVC ones from mcmaster for pretty cheap. I wish they were more like the tapered egg flat geometry because the sharp corners are deep and it's...

[psomero]

I despise the slotted platen that comes on arbor presses for 99.9% of the press work I find myself doing. I've been meaning to make a receiver socket...

[psomero]

Honestly, have them make DXFs and send them to a local laser or waterjet shop. You will probably get similar if not better precision out of either of...

[psomero]

"2200W frequency spindle"

Well, watts are power, not frequency.

Also, 2200W is roughly three horsepower. An aluminum...

[psomero]

Soak it in some LPS2, kerosene or WD40. I prefer the LPS but have used all three to degrease stuff fairly often.

Kerosene is a pretty good...

[psomero]

I'll bite

[psomero]

You serious about rebuilding it? Pm me...

[psomero]

Hard anodized aluminum riding in igus bushings. You're German, you'll dig it.

[psomero]

Do you need to control the speed of the motor or is it supposed to be fixed? I would not bother with trying to parallel h-bridges or using them as gate...

[psomero]

I had the opportunity to work with a number of folks who came from Buell after HD decided to murder the brand. They had stories, mostly of things not...

[psomero]

Of course all disc brakes drag, more or less.

My point is that harley brakes are worse, much like everything else on a harley, so the likelihood...