STP or Lucas motor honey
is what I found to be very good
for worm gear use.
I choose this for manual steering boxes
or snow blower...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Last edited by Doozer; Yesterday, 02:39 PM.
-
Be sure there is paper on the roll before sitting down.
-D
- Likes 5
Leave a comment:
-
Seems appropriate, as you typically argue both sides of a conversation
and when someone disagrees, you argue the polar opposite to get your jollies....
- Likes 6
Leave a comment:
-
-
These pills are to help you Jerry.
Play nice and the orderlys won't
have to call nurse Ratchet again.
-D
- Likes 1
Leave a comment:
-
It lacks the technical features that make it useful without work-arounds and modifications.
-D
Leave a comment:
-
I have always kept the hood and jaws dry.
Putting grease on the screw never seemed
to make the chuck self loosen, but maybe
you are...Last edited by Doozer; 02-06-2023, 04:28 PM.
Leave a comment:
-
Do you have,
states the obvious
and then agrees with both sides of the fence arguments
and in the end states nothing definitive,...
Leave a comment:
-
-
All these fancy tool holder holders are all about
obsessive compulsive disorder. More oppertunities
to assert one's dominance over organization,...
- Likes 2
Leave a comment:
-
High speed steel can run up to almost glowing without taking down the hardness while being USED.
-D...
- Likes 1
Leave a comment:
-
I do like 2 flute end mills for aluminum.
If it is a carbide 2 flute end mill,
I use them in steel too, up to their
physical strength...
- Likes 1
Leave a comment:
-
Seems like a lot of add ons and work arounds
for a press that has an inherent design flaw
of having the jack in the column stack.
I...
Leave a comment:
-
Don't hand job this thing.
It won't be straight enough.
-D...
Leave a comment:
-
Only grease the screw. DO NOT grease the inside of the hood
or the outside of the jaws. If you grease it, it will NOT grab a
drill bit. It...
- Likes 2
Leave a comment:
-
-
In my mind, wedges are only for one thing.
Removing a chuck from a drill press spindle
where the spindle itself has the Jacobs taper.
...
Leave a comment:
-
"Remove the spindle and body by pulling them straight out.
You should now be able to see the end of the arbor through the rear of the body,...Last edited by Doozer; 02-02-2023, 01:16 PM.
Leave a comment:
-
True.
But for some people,
a sky high double wide
is the pinnacle of aspiration.
He sets low goals for himself,
yet consistantly...
Leave a comment:
-
This typically works well. I have quite a few vertical indicators, I like them a lot.
-Doozer​...
Leave a comment:
No activity results to display
Show More
Leave a comment: