Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
No, but once you take it apart it is simple to see where the holes should go. No high accuracy required. Here is a site with pics. https://www.garag...
-
-
Hope this helps. Paddle was remoted for easy reach. Can still use box wrench by lowering spindle slightly....
Leave a comment:
-
A pilot light across the coil with alligator clips wired to where you can see it from a distance should show if the coil voltage is dropping out. If the...
Leave a comment:
-
Check motor dimensions against NEMA frame size chart. Then look at various motors in a cataog. Should get you in the ball park. Google numbers in pic...
Leave a comment:
-
I have removed many in cast iron from 3/8 to 3/4 using wire feed with gas shield. Some were broken below the surface where a tig would not reach. I would...
Leave a comment:
-
Use a boring bar with 2 cutting edges. Drill or end mill.
- Likes 1
Leave a comment:
-
Drive hole saw slowly to reduce heat build up. If chips are blue you are too fast. When drilling downward on thicker metal, drill one or two 1/4 holes...
- Likes 1
Leave a comment:
-
Newer propane tanks have a restrictor in the valve for maximum withdrawal rate, noticeable when using a weed burner torch. The valve has a three lobed...
Leave a comment:
-
Much of the machining content is about problem solving. So is much of the ot, but on a more personal level with problems we all share as we get older....
- Likes 2
Leave a comment:
-
Probably klacking on the back gears like mine does with a fly cutter.
- Likes 1
Leave a comment:
-
I don't understand your logic. Ten meters of wire is much less expensive than installing 3 vfds. You also get the benefit of instant reverse on the mill...
Leave a comment:
No activity results to display
Show More
Leave a comment: