Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Thanks for the comments Gary, I finished the flue extension today, and will start the fitting tomorrow, if it doesnt rain. I am going to remove the H...
-
Hi J Tiers, I think you are right, I have pushed the envelope a bit too far! The actual flue diameter of the forge hood is 10", I have reduced this...
Leave a comment:
-
Thanks once again Franz, I had considered putting the fan in the bottom of the vertical flue, but didnt as it would mean waterproofing it, and also I...Last edited by hermetic; 11-30-2019, 04:59 PM.
Leave a comment:
-
Hi all, as usual, I didnt get s full week in the workshop this week, but fitted s new motor to the old fan housing, which is much more powerful, and very...
Leave a comment:
-
Thanks Franz, that is good information! The pipe from the fan does go into the centre of the outlet pipe although it looks nearer the bottom, inside,...
Leave a comment:
-
Hi chaps! Not much time spent in the workshop this week, but managed to get a bit done, failures and succeses!¬ and as an added bonus, a car repair,...
Leave a comment:
-
Just to add to the problems, the main flue fan quit today! that gives me the opportunuty to fit a bigger one. The heater will actually run very happily...
Leave a comment:
-
No Doozer, that is not the problem, the blue roller shutter is not sealed at all, and the wind blows in! The flue/ flue fan is fine for the workshop woodstove...
Leave a comment:
-
My week this week! My workshop videos.
Hi Chaps, many of you have suggested that I post all my videos in one thread, and I have decided to give it a go and see how it works out. From now on...
-
hermetic started a topic Cooker hoods, a smoky Allday forge, and a noisy lathe! My week in the shop!in GeneralCooker hoods, a smoky Allday forge, and a noisy lathe! My week in the shop!
Well it has been an interesting week! I filled the bosh on the forge, added a bottle of CH leak sealer, and waited! after 3 days, not a drop of a leak....
-
BF and OaklandGB, given that the title of this forum is Homeshop machinist, and I am a home shop machinist, I chose to post about that rather than about...
Leave a comment:
No activity results to display
Show More
Leave a comment: