I was hoping that you built one that just uses a flywheel like this:
https://youtu.be/ZbxpfuIviao...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Success!!! Motor runs a full speed now! Not sure what made the difference. I took the motor apart, cleaned the contacts, and squirted a little oil on...
Leave a comment:
-
Unfortunately, I already returned the replacement capacitor, so I can’t measure its capacitance, or try try using both at the same time.
...
Leave a comment:
-
I’ll need to go back and read all the comments, but here’s a few questions I can answer now.
I. don’t have way to check the actual...
Leave a comment:
-
Mikey,
Original capacitor is 300 uF 125VAC the replacement I tried was marked 270-324 uF 110VAC. Testing the capacitors as shown in the link below,...
Leave a comment:
-
Thanks BCR!
At speeds higher than 1065RPM, it never reaches full speed, keeps groaning until it trips the breaker (20 amp).
...
Leave a comment:
-
Help with mill motor
Thanks in advance for any help on this. The motor in my RF-30 Mill/Drill makes noise on startup and won’t run at speeds higher than 1065 RPM. It’s...Last edited by Hawkeye; 03-29-2023, 03:22 PM.
No activity results to display
Show More
Leave a comment: