Thank you all for your ideas.
I think the most straight forward plan is to make a face mount bracket to hard mount the pump to the platform...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
aribert replied to OT-looking to gather ideas-how to support cantilevered load on horizontal shaft motorin GeneralNo - it was a pain to remove the broken off bolts as they were Loctited in place (permanent, red). I had to heat the joint so that I could remove the...
Leave a comment:
-
aribert replied to OT-looking to gather ideas-how to support cantilevered load on horizontal shaft motorin GeneralNoitoen: Thank you for the image / info on the chain coupler. I was unaware of these. I found a potential source here: https://www.surpluscenter....
Leave a comment:
-
aribert started a topic OT-looking to gather ideas-how to support cantilevered load on horizontal shaft motorin GeneralOT-looking to gather ideas-how to support cantilevered load on horizontal shaft motor
Collectively I would like to pick your brains for suggestions.
My logsplitter - home built by someone other than me but since modified by...
-
A key phrase - AT A JOB SITE! I broke a small diameter drill bit and then two backup bits while working on a rental. Home Depot is about 2 miles away....Last edited by aribert; 05-09-2022, 01:40 PM. Reason: apparently "#8" without quotes appears as "Private Messages" link
- 1 like
Leave a comment:
No activity results to display
Show More
Leave a comment: