Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
With tight push fits where you know it is meant to come apart just put on some music with a good rythm. Pick up the gear pair holding the larger gear...
-
I don't see the point of the initial Ni - Ni electrolysis. without a specific Ni salt solution I think you are just electrolysing water with the acid...
Leave a comment:
-
Whether it is a bar held in a collet in th ealready machined hole, or making the body from a bit of round stock, or making the body from a bit of hex...
Leave a comment:
-
A simple trick to handle halfnut slop on the return run is to bias the saddle against the leading edge of the leadscrew using the saddle handwheel, sort...
Leave a comment:
-
I guess they want to cash in on people who don't have a set of loose changewheels having to buy taps. Else they would have made it 104tpi to fit with...
Leave a comment:
-
It's interesting to see the different standards in other countries. I've never seen a copper threaded fitting llike that - always brass. UK ironnmongers...
Leave a comment:
-
add 100lbs and you can start making youtube machining videos.......
Leave a comment:
-
I don't watch these things but often I'm using a product (not necessarily HSM related) and wonder how it could be so badly designed and get through Director...
Leave a comment:
-
So if the bullet has lost its spin does it fall point first or does it tumble? Things dropped from aircraft seem to need a tail fin.
I spend most...
Leave a comment:
-
Forcast threatening half an inch of snow might hit London. That will bring everything to a halt. Oh, hang on, this year it already is....
Leave a comment:
-
Only two levers on gearbox makes the number of threads available without fiddling seem likely to be low. Noticed towing eye on the end of the bed....
Leave a comment:
No activity results to display
Show More
Leave a comment: