User Profile
Collapse
-
You could tack weld a pin or bolt to one of the ends to chuck a drill, oil the hole to prevent seizing and use some sandpaper/cloth to smooth the "dings"...
-
👍 1
-
-
-
-
Another thing about soft starters is that they can be bypassed after start with a contactor and on a Delta connected motor, you can start a bigger motor...
Leave a comment:
-
-
At the rate he builds parts, he's had time to build a new engine....
Leave a comment:
-
-
Seven days and counting. Just to bring the thread back to the first page 🤪
Leave a comment:
-
-
The difference between VFD's and soft staters is substantial. VFD's change AC to DC and then shape this voltage into a three phase linear voltage/ frequency...You may only view thumbnails in this gallery. This gallery has 4 photos.4 Photos
Leave a comment:
-
-
You can get rid of the Star/Delta starter and install a soft starter for a smooth start without current spikes. These have an end of start signal to activate...
Leave a comment:
-
-
We have a grocery store that handles the check out automatically. Between cameras and RFID tags, you put your stuff into the shopping cart, pay to exit...
Leave a comment:
-
-
They must be so bad that many years later were adopted in the orthopedic surgeries....
-
👍 1
Leave a comment:
-
-
More than once long ago I adapted my old lathe's top slide assembly to the back cover of old ship dc generators and used their giant diesel engines as...
-
👍 1
Leave a comment:
-
-
Over here you even have to check out your own purchase at the grocery store, hardware store and all sorts of other purchases. Even at fast food restaurants,...
Leave a comment:
-
-
Since I would rather make than buy, I made my own water cooler out of a small ice cube maker. It was going to be recycled at work so I repurposed it....You may only view thumbnails in this gallery. This gallery has 4 photos.4 Photos
Leave a comment:
-
-
If you haven't, you must get air assist. When I tried my laser for the first time, on the second day, the results went down the drain. Some debugging...
Leave a comment:
-
-
I would think that all the different angles between Morse tapers was not by chance. Mr. Morse must have thought it thoroughly through before registering...
Leave a comment:
-
-
I would make a little tube out of a thin plastic bag and pack th hole tight with some "clay like" substance like plasticine or air dry crafts...
Leave a comment:
-
-
Since the original title is "Laser Etching", Iv'e successfully used to prepare copper circuit boards and stainless steel nameplates to be etched...
Leave a comment:
-
-
PVC is a no, no for laser cutters. besides being poisonous, it will corrode the machine with the acidic fumes generated....
-
👍 1
Leave a comment:
-
-
Last time I checked, this turned out to be a general gossip forum so, laser discussions are welcome 😋 OT: Has anyone heard from Brian?...
Leave a comment:
-
-
I've many hours with my 12 year old K40 and never felt the need to change the controller. I draw on autcad, save regular .DWG in 14 format and read directly...
Leave a comment:
-
No activity results to display
Show More
Leave a comment: