Those Doall guys had their Ducks lined up!

[Tundra Twin Track]

X2 what Doc said,but I am a fan of Mobil 1 full synthetic.

This is history on a 94 GMC 454 engine from new to engine disassemble after 556000...

[Tundra Twin Track]

Was the original table damaged by some one using it as lifting point with forklift,you should post pics of your Saw does it look the same as my 1950 ...

[Tundra Twin Track]

Some Ag Machinery manufacturers should focus more on the correct mechanical designs than the electronic gadgetry that so many company's promote.One manufacturer...

[Tundra Twin Track]

The plate was for the Big Dake #6 Arbor Press,was building some conveyor rollers that needed pulleys pressed in,at 46" long...

[Tundra Twin Track]

This setup works great contour Cutting as well about 20 min to cut this 1-1/4" plate with 6 tooth blade,all with power feed ...

[Tundra Twin Track]

Thanks,the Blade Welder was in it but opted not to reinstall as my patience & time was running out towards the end of refurbish....

[Tundra Twin Track]

The Doall was Powder Coated and is real easy to clean,the Wadkin gang Drill not so much found out later there was not enough hardener in the paint that...

[Tundra Twin Track]

It's one of my favourite machines I have,prior to getting this 1950 ML,I had a Doall 1957 LSV 16" but when I spotted this at a RB...

[Tundra Twin Track]

The position of the cable pulleys doesn't really matter and it's up to the operator to stop before hitting the roller chain,if workjaw is used it can...

[Tundra Twin Track]

Use a Dremel with the cut off zip blades,may use a few blades but their cheap.

[Tundra Twin Track]

Have posted about this Vertical Doall before but had to mention it again,needed to split some 1/2" flat bar with as little distortion as possible.This...

[Tundra Twin Track]

Bented I'm a real slowpoke I do just about all of my Lathe work at 400rpm and Carbide exclusively except for Plastic&Rubber which I use razor sharp...

[Tundra Twin Track]

Those work great,I have similar Cutters that I've used for turning&facing also....

[Tundra Twin Track]

Slushy Machine may have been handy at a couple Golf Tournaments I hosted in the shop a couple years back in mid winter.There were no Drivers allowed in...

[Tundra Twin Track]

Just what I need another machine to clean&service can't drink hard liquor anymore just MGD beer makes me happy after a few....

[Tundra Twin Track]

Those were my thoughts also,the rack tooth spacing on my Greenerd 3-1/2 is identical to the ones on Drill Press Heads I used on the Wadkin project.A lot...

[Tundra Twin Track]

Nothing on the drawing board at this time,but I'm sure my imagination will get motivated at some point lol! I couldn't let all those good parts be melted...

[Tundra Twin Track]

I haven't come to my senses yet lol,I actually like the 4 jaw scroll 4"&8" I just grip them in my 3 jaw quick and easy.There accuracy is...

[Tundra Twin Track]

I do have a selection of stuff (0k Junk) that is out of sight from main yard and house,have seen the odd rustic type yards where the goodies are piled...

[Tundra Twin Track]

That's kinda big,thought maybe you had a 4 to 6" laying around....