User Profile

[Captain K]

https://m.kmstools.com/index.php?mai...ucts_id=174709

They're available...

[Captain K]

Most times 5/16-32 is close enough and taps/dies are available...

[Captain K]

I would try a left hand drill. Allen bolts are often hardened so may not work. Before that I would try a torx driver driven in, then vice grips, then...

[Captain K]

Duplicate post

[Captain K]

I checked this morning. 3 wire control doesn’t work with continuous on signal. Stop button does nothing if I hold in the start button

[Captain K]

Noitoen has the better idea I think. All of my other suggestions should be considered through his lens. rdfeil got me to go back and look at OP. I finally...

[Captain K]

For 3 wire operation you use fwd,rev,cm and an x terminal set to 6. Page 5-51 in my manual. I have one set up for 3 wire, I’ll see what happens when...

[Captain K]

You should be able to set it up with an nc switch on the foot brake in the common wire. If there is a break in the common it should not restart until...

[Captain K]

How did the foot brake turn off the lathe originally? Should be able to make it work with existing switch. I have a few frenic minis, you should be able...