User Profile

[epicfail48]

Already been said, but those are the screws that generally come with door hardware like strike plates. I believe the theory is that they work in both...

[epicfail48]

I take offense to that. Ive been running the iGauging scales on my mill, hooked up to a blueDRO box, for a couple years now. Works plenty fine as a 'real"...

[epicfail48]

Ive been wondering for a few days now, what problem is there with a brace again? Sure, theyre most commonly used with self-feeding auger bits, but its...

[epicfail48]

I mean, I had some 'hands on' experience a few years ago, broken wrist. Pretty neat stuff, nurse just dunked it in water, wrapped it over the gauze and...

[epicfail48]

You know, that makes me wonder if a binary explosive like tannerite wouldnt work for the same purpose... Not technically an explosive according to the...

[epicfail48]

I know that er32 collets have a 1mm range, i.e a 14mm collet should be able to hold anything between 13mm and 14mm. In your case, you should be able to...

[epicfail48]

Dont recognize the brand name, but i did have a drill sharpener like that. Mine had attachments for sharpening knives and scissors too. Didnt do it well,...

[epicfail48]

Thin stuff id imagine that a unibit or a spur/brad point drill would do best, long as you needed round more than precise size. If you wanted precise size...

[epicfail48]

Im confused about the people claiming that the thread size doesnt matter. With straight infeed, wouldnt a lower pitch thread lead to more cutter engagement...

[epicfail48]

....right up until reading this it never occurred to me I could do that...

[epicfail48]

The ender series is a fantastic place to start. The 3 is the most recommended as it's dirt cheap but still gives fantastic results, but if you can swing...

[epicfail48]

Everybodys jumping to the expensive options, yall missed the cheap one; shopvac filter bags are a thing. Stick one of those in there, it contains the...

[epicfail48]

Id go with steel over brass. Table saw blade is hardly a permanent installation, and installing and removing the blade on the arbor will loosen up the...

[epicfail48]

Some people look at practicality of these, and i feel that kinda misses the point. Nobody swaps a random engine for practical reasons. Maybe a 1-1 swap...

[epicfail48]

If only we were all fortunate enough to own turret lathes with geometric threading heads and a full set of dies...