Bison cam lock vise?

[DennisCA]

But are you using the oxy propane correctly? Are you holding the torch further away or as close as you would acetylene, that seems to be a common problem...

[DennisCA]

I bought a mig welder. Bit tight in the shop for the forseeable future but a new building is on the way so I can move a lot of stuff out that doesn't...

[DennisCA]

I can't pretend to know that for sure, but everyone I've talked to that has given the impression of competence and not boasting, says yes, but requires...

[DennisCA]

I take the piece I want to bleach and brush on the cream, then I wrap it with plastic wrap to prevent evaporation. Then I put it in the sun, or if you...

[DennisCA]

Put in a bid on a 2nd hand mig welder, 250 amps 3-phase, seller approved so tomorrow I am going to go look at it, and hopefully bring it home:
...

[DennisCA]

I am moving towards Oxy Propane instead of Oxy Acetylene, safer and cheaper, don't plan on gas welding. I am told that oxy propane cuts as clean as oxy...

[DennisCA]

Hair bleaching products. I have some 12% Peroxide cream that I use for de-yellowing old plastics to make them look new again.

[DennisCA]

A plasma that can cut as thick as an oxy-fuel torch would be very expensive. I only have a plasma cutter, but it maxes out around 1 inch.

...

[DennisCA]

Rust bluing has worked for me the times I've done it. I used fume bluing (put the part in a container hanging from a wire with some acid) and a special...

[DennisCA]

Thanks, the anvil is a 69kg / 151 lbs anvil and it's a Swedish Söderfors, made in 1910s sometime, the last number is too badly damaged to tell. The narrow...

[DennisCA]

Finally got the tongs done, not that happy with them but I guess the first pair are never gonna be the best:



The rivet is an...

[DennisCA]

I have seen those around, if you mean the type Stefan Gotteswinter uses nowadays. Expensive though.

[DennisCA]

I understood one way, used on regular milling vices to some extent, was to make the moving jaw lean a little "forward", the deflection from...

[DennisCA]

That's a great explanation Paul, thanks. Though I really meant "lift more than any other machine vise"

And if anyone from europe...

[DennisCA]

I found a Rohm 711 130mm vise for cheaper now, so I am getting that instead I think, it's a low profile conventional screw vise.

[DennisCA]

It's not an important feature since my mill table swivels, but it would probably be easier to zero the vice than the table after doing that. Since I am...

[DennisCA]

It doesn't seem many people here know of this vise and many seem to assume a lot of things about the construction or origin but i don't see any actual...

[DennisCA]

199€ + shipping

This is the modern version, this is an older model:
https://www.cutwel.co.uk/camlock-mac...son-6517-bison
...

[DennisCA]

I've had some help elsewhere and the vice is screw based, the cam lock refers to the fact that the movable jaw can be released and moved around and held...

[DennisCA]

Looking at buying this vise. It's a bison and 125 mm or 5", I was wondering if anyone had experience with these types of vices? The model number...