Lathe motor soft start

[I make chips]

So here's what I did since soft starters are so spendy
The tensioning assembly works as it should. On that hanging contrivance is the motor and...

[I make chips]

I have it all solved and it's a rather fun solution when explained to others. Measuring can be simplified..
I have a tape measuring device that...

[I make chips]

Nothing big, just a 1/2 hp 120 volt induction repulsion cap start motor on a 9" south bend.
The motor is the under mount design on a swinging...

[I make chips]

As posted many points of origin can be valid. Do your own searching with soap water etc. It may be the stem, the core, a bead leak, porosity in the tire...

[I make chips]

A bit like this George?
https://www.youtube.com/watch?v=LONT1oboJrs...

[I make chips]

Vibratory bowl feeder to pass small parts to a processing machine.Other stuff is not related.
https://www.youtube.com/watch?v=_3envoV7l0Q...

[I make chips]

https://www.ebay.com/itm/13-Quart-Do...0AAOSwlj9d6hVd

https://www.ebay.com/itm/10-Quart-Si....c101195.m1851

https://www.eba...

[I make chips]

Mike Edwards FTW with the 10mm multipack!

True story. A buddy lives near Phoenix and was out hiking in the desert and saw a flash. Yes in...

[I make chips]

To perpetuate arguing, the part is the die cast aluminum tail shaft housing for a car/truck driveshaft yoke to slide into. It bolts on the back of the...

[I make chips]

^ Yup, it's all about liability. Imagine if the kid did something dumb like we do almost daily and he cut a finger off. There would be a $200 million...

[I make chips]

This thread reminds me of the consummate missing 10mm socket. Seemingly made of mystery material lighter than air they go awol periodically never to be...

[I make chips]

OP: Search for DU bushings. (Delrin Urethane) You'll find the bushing on someone's shelf.

[I make chips]

We all have the doorway effect, also called threshold reset. As time goes on we associate this with losing our mind but relax, we're not.

...

[I make chips]

A gunsmith friend has a small shaper. He made a surface plate about 10x12 inches and set the machine up to do fine cuts with a minimal step over. We...

[I make chips]

Also had to wiki it.

Another mindless show that well suits the mentality of Americans. Dumbed down to almost nothing.

[I make chips]

When I open Aliexpress the site is in cyrilic. Wonder if the russians hacked it?
I'm trying to get in to track an order for some carbide inserts...

[I make chips]

You need a high carbon steel to make springs. 6 or more points of carbon. 1065 to 1095 are typical alloys used.
Harden and temper it to the desired...

[I make chips]

Might I add that baking varnish is rather benign. Put it on some aluminum foil to catch the drips, not one of wifey's cookie sheets.
*I bake things...

[I make chips]

Tesuckems vibrate like mad. Run it or put something different on it. Timing is by point gap and regardless, it won't affect vibration.

[I make chips]

The frequency can't change assuming it's powered from the wall socket 120 volts. The power grid is very stable so I suspect your measuring equipment if...