Milling Feed and speeds question

[flathead4]

I am fortunate to have room for an NMTB 50 horizontal and found one local for cheap but this is still good info because even though I don't have a pile...

[flathead4]

Do you adjust the headlights after jacking up the front end?...

[flathead4]

Thanks for the comments. That's what I was looking for. I think I just might be able to get that piece clamped to the table.

[flathead4]

I cut the table feed to 7 ipm and it still cuts fine but less "exciting."...

[flathead4]

The piece does go all the way bottom of the vice jaw. And the cut was from left to right so I did not climb mill it....

[flathead4]

I bought a Kempsmith horizontal mill several years ago but have mostly used it to cut aluminum (which it cuts like warm butter) and to saw up some 1/4"...

[flathead4]

Not unlike a revolver. If you have a misfire, just pull the trigger again. Well, a revolver on steroids....

[flathead4]

I am not a brick layer but are you really using concrete instead of mortar?...

[flathead4]

Just looking at it, I would bet the saw would fail before anything on that shaper....

[flathead4]

I've used them to seal the corners of home made aluminum trays and to fix an old sinker mould once. The joint has to really be clean. I don't recall much...

[flathead4]

Could is not equal to should. I would guess that you would pay more in labor than for a replacement tranny. Are you sure you are not pulling our leg...

[flathead4]

Northern tools sells a 30" breaker bar for not much money. That would at least take the pipe out of the mix.

https://www.northernt...

[flathead4]

Do you have chatter in all kinds of metal? Are you using a lubricant?

[flathead4]

To remove lug nuts from my truck I use a socket with an extension to get past the tire. Then a 1/2" breaker bar with 3 foot length of pipe usually...

[flathead4]

With no height adjustment and the angled slot for the tool, it looks purpose built for that lathe and hand ground HSS. Interesting take, though.
...