.png)
Stu
Senior Member
Last Activity: Today, 10:47 PM
Joined: 07-05-2007
Location: SE PA
-
Hey RB you were right, I got it to calibrate. Thanks -
You may be right, maybe I'll try it with my finger on the off switch so I don't crash it.Leave a comment:
-
I have checked the switch and it is correct. The interface I use Pronterface shows whether any of the end stops are open or tripped confirming my multimeter...Last edited by Stu; 01-13-2021, 08:40 PM.Leave a comment:
-
OT 3D printer problem
I was gifted a not working Anycubic Kossel linear plus 3d printer that I’m having problems with. The Z axis end stop probe does not stop the z axis... -
Have you considered Cordura? I make carpenters tool pouches from 1000d Cordura and it is a nice material and could work out for your ideaLeave a comment:
-
Leave a comment:
No activity results to display
Leave a comment: